Christmas Card with Stamped Bubble Bauble and Ribbon

Hi everyone, this lovely card was made by our guest designer Garcia, with the new Bubble Bauble with Ribbon stamp. For this card Garcia used the co-ordinating Bubble Craft Die to cut coloured paper to fill the larger bubbles. The effect is lovely.

To Make The Card

Start with a DL card blank, cut dark red card to 10cm x 20.5cm and white card to 9.5cm x 20cm. Stamp the bauble at the bottom of the piece of white card with Versamark Ink and heat emboss with silver embossing powder. Ink over the white card including the stamped image, with a foam ink blending tool. Use marker pens to colour the ribbon, to match the dark red card and the bauble cap. Use a ruler and marker pen to draw a line from the ribbon to the top of the card. Layer the stamped piece and the coloured card together and mount on to the base card.

With the Bubble Craft die, cut circles of coloured paper, sufficient to fill the large and medium circles on the bauble. Glue these into place, then fill the small circles with 3D Pearl Accents.

Stamp the greeting on to white card, and heat emboss with silver. Trim the sentiment into a tag shape and layer onto dark red card. Adhere this above the bauble slightly overlapping the string.

This is a gorgeous card, with an unusual colour scheme and lots of detail. Thank you for visiting, I hope you like it too, all the supplies used are listed below.

Debbie x

Supplies used:

• White DL blank card and envelope
• Dark red card, pink and purple paper
• A4 Coconut White card
• Bubble Bauble with Ribbon clear stamp set
• Press to Impress stamp positioning tool
• Versamark Ink pad
• Metallic Silver embossing powder
• Sizzix heat gun
• Shades of red and grey marker pens
• Foam ink blending tool
• Distress Oxide ink pads, Faded Jeans, Tumbled Glass
• Bubble Craft die
• Big Shot die cutting machine
• 3D Pearl Accents Purple Violet, Teal Sky
• 3D Silver Sparkle Accents
• Woodware Crafty glue
• Double sided tape runner